- Déc 13, 2020
- Non classé
- 0 Comments
So why does one of B-IP`s calls suddenly use the WS channel when there is no shipping agreement? What other configuration could this cause? A web service is an application function or service and can be used by the Internet standard. It is an independent, modular and self-prescribing application function, or a standalone service. But the Channel Response channel says that « No proper channel agreement found » error. The call adapter is at the entrance to the pipeline in the information monitor. There may be a number of HTTP communication errors. Further analysis of the cause of the problem can be accessed in the HTTP error code documentation. No standard agreement for , TR , XXX_60, test found, make sure that your sending agreement is correct and connected to a correct communication channel. Error of use – There is an error at the end of the recipient while a message is being processed, and the sender is not aware of this error and is still waiting for the response. There is no dump in ST22 and this error is due to the fact that the transmitter system sends exponential value into one of the decimal fields. Problem appeared in the receiver agreement for the transmitter -SAPR/3 to the receiver P_GDDXI-S_HTTP,urn:sap-com:document:sap:idoc:messages. Type IDOC: No standard agreement for , SAPR/3, P_GDDXI, S_HTTP, urn:sap-com:document:sap:idoc:messages, IDOC Type Plus, 3 receivers Comm Channels and 3 Receiver Agreement and 1 SenderVereinbarung. A chain chord, a definition of an interface, a detection receiver is sufficient and works. Error in the reply message – In this scenario, there is an error, and the reply message remains stuck in between, and the sender continues to wait.
Therefore, if errors occur in the integration engine, this information can help you find problems. Typical error categories are described in the following chapters. Try to find out in which component XI the error occurred. The candidates` components depend on the scenario used. The standard scenario includes a transmitter system, the integration server (IS) and a receiver system. Basically, there are two ways to know in which system the error occurred: use end-to-end monitoring, or browse the systems step by step from the sender, then the IS and finally the receiver system with individual monitoring tools. This adapter is used to provide connectivity with WS providers and WS consumers according to the standard WS-RM (Web Services Reliable Messaging) protocol. SAP developed the WS-RM protocol with its own inbox, which is implemented in the ABAP battery on the integration engine. If the IDoc adapter is not properly configured on the integration server, these errors become visible on the sender system. Check the SM58 transaction to see the failed IDoc functional blocks. In the event of an authentication or authorization error, you can also find information in the system log (SM21 transaction).